Pneumatic Crimping Tool for SC30 and PP3 Machines

New pneumatic tool APPL.PP3.P is a highly reliable crimping tool designed for crimping the contacts in the strap. The tool can process these contacts in the cross-section range from 0,03 mm2 to 1,5 mm2 (AWG 34-16). The tool uses its own pneumatic cylinder to feed the contacts and the switching is ensured by the pneumatic distribution of the machine PP3+.

This model is a more inaccurate variant for PP3+ machines and fully replaces the mechanical type. The tool operates in principle of two separated units moving against each other. It is clamped into the machine PP3+. The crimp punches, entrainment unit and trimming pressing part are situated in the upper part. The anvil is clamped in the lower part and cutting unit in the front.

This enables to achieve the precise and sealing crimp connection (documented by the test protocol and the cut method) and guarantees the highest level of quality. The tools are designed for PP3+ and SC30 machines which are always equipped with the stripping unit with precise knives and jaws which ensure the stable fastening of the wire throughout the crimping and stripping process with the fine clasping sensor that clasps even every thin wires with the ejector of the crimped wire. The machine is one of the most precise and fastest machines in its class and it is quite unique in some features.

Also the tool APPL.PP3.P can beused in an old PP3 machines
after a simple modification.